Ubuntu Linux Gateway Example: Difference between revisions
| Line 29: | Line 29: | ||
===IP Addresses=== | ===IP Addresses=== | ||
====Static IPv4 from your ISP==== | ====Static IPv4 from your ISP==== | ||
=====What is a Static IP ?===== | |||
Normally your ISP assigns you an IP address dynamically from a pool of IP addresses. | |||
====Private IPv4 Addresses for "Non-Ham" Devices==== | ====Private IPv4 Addresses for "Non-Ham" Devices==== | ||
====AMPRNet IPv4 Address Allocation==== | ====AMPRNet IPv4 Address Allocation==== | ||
Revision as of 23:34, 29 March 2014
The following are the steps necessary to create a general purpose gateway to AMPRNet using an Ubuntu Linux Server.
Not everyone needs a gateway!
You only need to setup a gateway if:
- You want to access AMPRNet resources that are not accessible from the Global Internet.
- You want to provide access to AMPRNet over RF (via packet or using WiFi).
Design
The basic design consists of a standard PC running Ubuntu 12.04 (LTS) and three network connections:
- The first connection is to your ISP so you can reach the Internet.
- The second connection is used to connect your normal "non-ham" devices to the Internet.
- The third connection is used to connect your "ham" devices so they can see and be seen by other AMPRNet devices.
The following diagram shows the layout of the connections. (Click on the image to enlarge).
Error creating thumbnail: File missing
Prerequisites
Hardware
I'm running an old Dell Optiplex GX260 (a Pentium 4 with 512 MB of RAM and a 20 GB Hard drive). You don't need much if your Internet Service Provider's bandwidth is 100Mb/s or less.
Along with the built in Ethernet network interface, I've installed two additional 10/100 Ethernet network cards I purchased from Amazon.
Software
On the Dell I've installed Ubuntu 12.04 LTS (the 32-bit server version).
IP Addresses
Static IPv4 from your ISP
What is a Static IP ?
Normally your ISP assigns you an IP address dynamically from a pool of IP addresses.